Anthem Support

To perform a power cycle, power down the unit and disconnect the power cord. Press the front panel power button 4-5 times to drain residual power. Once this...

If you encounter issues with the Play-Fi app check if your network setup includes a mesh network or an ethernet switch. If yes, try to bypass the mesh/switc...

No, the Web GUI was implemented for our newer models and is only available for 4th generation models, such as the MRX x40 and AVM 70/90.

No, The 8k board upgrade program is exclusively available for the Gen 4 models.

No, MRX x20 and AVM 60 units do not come equipped with Bluetooth functionality.

Please refer to Page 17 Section 3.1 of the Manual for AVM 60/MRXx20 (https://anthemav.com/downloads/avm-mrx-english-manual.pdf) as this would detail the pos...

You will need a USB drive that is formatted to .fat32. The firmware file can be found on our website under the downloads section of the unit you have or the...

There are several methods to connect these units to your Wi-Fi network. The simplest method would be via the Manual setup via the unit’s menu system. Here y...

Regarding the FM antennas, there are no distinctions among the mentioned units. All of these models utilize the same antennas for FM radio reception.  H...

In order to reset your third-generation MRX, 520/720/1120 or AVM 60 please use the steps below.  Please note before performing the reset, that all se...